Tech-source Raptor 4000 Series (for Linux) Manual do Utilizador descarregar pdf (Página 40)

Raptor 4000 Series: Reference Manual

To enable DDC mode, the “DDCCheck” “off” option must be

commented out in the “Device” Section of your Raptor card.

This line option can be found in the xorg.conf file and must be

commented out prior to starting the Xserver.

In the example provided, Option “DDCCheck” “off” is

commented out, so DDC will be enabled.

Section "Device"

Identifier "Rapafp0"

Driver "rapafp"

BusID "PCI:2:9:0"

Card "TSI Raptor 4000"

Option "Device" "/dev/rapafp0"

Option "Mode" "24"

Option "ScaleCursPos" "on"

Screen 0

Option "Head" "0"

# Option "DDCCheck" "off"

# Option "Rotation" "+r"

# Option "Sync" "sx"

# Option "BackingStore"

# Option "SaveUnder"

# Option "TranspColor" "0x0a3246"

EndSection

4.7.3 Setting Mode Line

To select a specific mode line and refresh rate, both the Monitor

and the Screen sections of the configuration file need to be

modified. The configuration file used in the following example is

/etc/X11/xorg.conf. If the mode line you wish to use for you

display is not listed, then a list of supported resolutions along with

their corresponding timing numbers is available in the file

/etc/X11/rapafp_modeline.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 63 64

Sem comentários

Tech-source Raptor 4000 Series (for Linux) Manual do Utilizador Página 40