Tech-source Raptor DL-Lite Drivers for Solaris Manual do Utilizador descarregar pdf (Página 12)

Raptor DL-Lite Drivers for Solaris Installation and Reference Manual

3-2

3.3 CD-ROM Installation

The following are step-by-step instructions for installing the

Raptor DL-Lite Drivers for Solaris Software from a CD-ROM.

1. Install a Raptor card in the computer as described in

Chapter 2.

2. Boot the computer with the -r (reconfiguration) option.

To do this on an UltraSPARC workstation, perform the

following steps:

• Power ON the computer.

• Wait until you see boot messages displaying on the

screen, then press and hold the Stop (L1) key, and

then press the A key.

• At the ok prompt, type boot –r.

3. After the system comes up, log in as root.

4. Insert the CD-ROM labeled “Raptor OpenWindows for

Solaris Software” into the drive.

5. If /cdrom/cdrom0 exists, the CD-ROM was

automatically mounted. Change directories to the CD-

ROM by typing the following:

prompt# cd /cdrom/cdrom0

If /cdrom/cdrom0 does not exist, mount the CD-ROM

by typing the following:

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Sem comentários

Tech-source Raptor DL-Lite Drivers for Solaris Manual do Utilizador Página 12