Tech-source Raptor Drivers for Linux Manual do Utilizador descarregar pdf (Página 16)

Raptor Drivers for Linux Installation and Reference Manual

3-2

The software has been fully tested under Red Hat 7.3, Red Hat

8.0, Red Hat 9.0, Red Hat Enterprise Linux (32-bit only) and

SuSE 8.2. Updating or recompiling the kernel or the XFree86

distribution may cause the driver and DDX to fail to load. In

this case, please contact our technical support team for a

possible solution (See Chapter 7). The software consists of the

following modules:

raptor.o Kernel driver for the Raptor 2000

rapqfp.o Kernel driver for the Raptor 2500

tsi_drv.o XFree86 DDX module

libMOX.a MOX extension module

3.3 CD-ROM Installation

The following are step by step instructions for installing the

Raptor Drivers for Linux from a CD-ROM.

1. Login as root on the target system, using /bin/sh as

your shell.

2. Insert the CD-ROM labeled “Raptor Drivers for Linux”

into the drive.

3. If the drive is already mounted, type:

prompt# cd /mnt/cdrom/linux/i-class

4. If the CD-ROM is not already mounted, type:

NOTE: Rebooting the system after the Raptor card installation

may cause the auto configuration manager to come up in

some distributions. At this point, ignore the auto configuration.

Refer to Section 3.6 to configure the Raptor card after the

software is installed.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

Sem comentários

Tech-source Raptor Drivers for Linux Manual do Utilizador Página 16